Ships in 1 - 10 days!
Part Number: 1791284 UPC: 662755464232 Weight: 1280



• Sliding table with 4-foot stroke works with miter head, hold-down and fence to accommodate everything from multiple end cuts to tenons

• Fully adjustable fence with dual digital readout for fast, accurate set-up and repeatability

• Large table with built-in slider with room for stock feeder

• 7" vertical spindle travel allows stacked tooling

• Spindle tilts negative 5° to positive 45° for increased versatility

• Large diameter multiple table inserts accommodate virtually any size cutter

• Five spindle speeds in forward and reverse with lighted indicator


• Electrical Controls: 24 volt

• Table Inserts (In.): 2-1/5, 5-1/2, Oval (Tilting)

• Reversible: Yes

• Spindle Size Under Nut (In.): 3/4 (3-1/2), 1 (6), 1-1/4 (6-1/2)

• Recommended Circuit Size (Amps.): 30/15

• Table Travel (In.): 49-1/4

• Maximum Diameter Cutter Above Table (In.): 12

• Maximum Diameter Cutter Below Table (In.): 9

• Motor Phase: 3

• Router Bit Collet Included: 1/4, 1/2

• Dust Collection Minimum CFM Required (CFM): 800

• Fence Travel (Major and Minor) (In.): 5-3/8, 3-5/8

• Spindle Speed (RPM): 3,000, 4,000, 6,000, 8,000, 10,000

• Motor Voltage (V.): 230/460

• Table Size (In.): 51-1/2 x 33-1/2

• Fence Size (L x H) (In.): 46 x 5

• Dust Port Outside Diameter (In.): 5 (x2)

• Maximum Spindle Diameter (In.): 1-1/4

• Style (Type): Shaper

• Spindle Tilt (Deg.): 45 Forward, 5 Back

• Spindle Travel (In.): 7

• Prewired Voltage (V.): 230

• Spindles Included: 3/4, 1, 1-1/4

• Sliding Table Size (In.): 11-1/4 x 51-1/4

• Motor Power (HP): 7-1/2

The new TS29 Tilt/Slide Shaper is ready to tackle any job. A new fence design includes dual digital readouts, micrometer adjustments and independently adjustable fence halves for fast, accurate set-ups. The full guard includes two stock hold-downs and a see-through cover that flips up for quick tool changes. Dual dust collection ports, in the guard and under the table insure a clear work area and improved finish. An extra large quill assembly with a full seven inch stroke has three oversize bearings and the ability to tilt, adding versatility and insuring long, trouble-free performance. Powered by a big 7-1/2HP motor that drives the spindle forward and reverse with five speeds. The massive sliding table is fully supported by six tapered precision bearings through a full four-foot stroke. In addition, on board the table is a large miter head complete with stock hold-down clamp and a 56" miter fence with flip stop. The large table can easily accommodate a stock feeder for longer production runs.

Customer Reviews