SKU: Klein 1613-35
UPC: 092644471919
Weight: 2.98 lbs

Klein 1613-35 Chicago Grip - for Bare Copper Wire

List: $244.40 $132.44

You Save 46% ($111.96)

Special Order - Details

Details

FEATURES:

• Pulls #6 to #8 bare copper wire.

• Safe load of 4,500 lbs (2,100 kg)

• Locking loop handles allow the jaws to be held in an open position for easy placement on wire or cable.

• Single "V" groove jaw contour.

• Hot latch version available (1613-35H).

• Before each use, clean jaw area and inspect grip for proper operation to avoid slippage.

• When used on/near energized lines, ground, insulate, or isolate grip before pulling.

• Do not exceed rated capacity.

• Do not exceed rated capacity.

• Grips are to be used for temporary installation, not for permanent anchorage.



SPECIFICATIONS:

• Maximum Safe Load - lbs: 4,500

• Maximum Safe Load - kg: 2,100

• Jaw Length: 4-3/16" (106 mm)

• Outside Diameter: #6 and #8 Copper

• Sub Brand: Chicago Grip

• Weight (kg): 2.8

• Weight (lbs.): 6.25



Finding the best grip to pull small copper can be challenging. Copper stretches over time becoming too thin for some grips which may cause slippage. Some smaller grips are harder to manipulate when wearing rubber gloves and are not hot latch compatible. Using a grip that's too big, too strong or too aggressive could damage the cable. Klein Tools' 1613 Series Bare Wire Chicago Grip is big enough to work with gloves but small enough to pull #6 and #8 copper without damaging it. It's just right for the job.


CALIFORNIA RESIDENTS:

WARNING Cancer and/or Reproductive Harm – www.p65Warnings.ca.gov