Special Order Details Available for Backorder
Part Number: KC3540 UPC: 032076813093 Weight: 0.83125



• (1) Converter


• For use with 3-1/2" to 6" punches and dies

• Eliminates the need for spacers

• Helps to center the hole

• Requires 1.5 inch guide hole


• For use with 3-1/2" to 6" punches and dies

• Requires 1.5 inch guide hole

Use the Gardner Bender KC3540 Knockout Converter whenever you need to create larger punch sizes (3.5 to 6 inch). Designed for use with the GB KOH14A Slug-Out Hydraulic Knockout Set and compatible with most 3.5" punch and die sets the converter eliminates the need for spaces and helps to center the hole. Thread the KC3540 converter into the punch from the inside until seated making sure the die counter bore is positioned over the boss projecting from the port end of the cylinder. The converter requires a 1.5 Inch diameter or larger guide hole (use 1-1/2" punch and die) to be drilled prior to use. It is important to install the converter on the inside of the punch as damage to the pull rod would result from incorrect installation of the converter on the outside of the punch. Once you've placed the pull rod into the guide hole. Install the punch on the pull rod and turn until the converter is into the guide hole.

Customer Reviews